User manual AEG-ELECTROLUX HDINSTALLATION309000906

[. . . ] Inside, be sure furniture, drapes, or blinds will not stop proper airflow. Check the available electrical service - power supply must be the same as that shown on the unit serial nameplate. (See Owner' Guide for serial plate location. ) Power cord s is 48''long. All models have a 3-prong service plug to provide proper service and safe positive grouding. [. . . ] Shift cabinet left or right as needed to line up center of cabinet on center line marked on stool. Fasten cabinet to window stool with 2 screws into holes. (You may wish to pre-drill pilot holes. ) 5. Assemlle sill angle bracket to support brackets at the marked position, as shown. Install support brackets (with sill angle brackets attached) to correct hole in bottom of cabinet as shown. Tighten all 6 bolts securely. Bottom Rail Seal 1/2''long screws and locknuts 3/4''LONG HEXHEAD SCREW 4 6 Extend Window Filler Panels 8 1. Loosen screws so filler panels slide easily. Install Chassis into Cabinet and Install Front to Unit !Close window behind top angle. 7 Install Window Lock and Sash Seal 1. Insert into space between upper and lower sashes. WINDOW SASH SEAL 2. Attach right angle safety lock as shown. SAFETY LOCK 3/4''long hexhead screw 5 Thru-The-Wall Installation NOTE: Consult local building codes prior to installation, or a qualified carpenter. WIDTH " = 26-3/4'' (67. 9cm) plus twice the thickness X" of framing material used. HEIGHT " = 18-7/8'' (47. 9cm) plus twice the Y" thickness of framing material used. 2 1 Select Wall Location This air conditioner has a slide-out chassis, so it can be installed through an outside wall up to 12'' thick. NOTE: All parts neede for Thru-The-Wall Installation are provided, except a wood frame, shims, and 10 wood screws (# 10-1'' long minimum). does not support major structural loads such as the frame construction at ends of windows, and under truss-bearing points, etc. is near existing electrical outlets, or where another outlet can be installed. allows unblocked airflow from rear sides and end (outside) of installed air conditioner. Y Y 18-7/8'' (47. 9 cm) 26-3/4'' (67. 9 cm) 2. Prepare wall in frame construction (including brick and stucco veneer). Working from inside the room, find wall stud nearest the center of area where air conditioner will be installed (by sounding wall, or by magnetically inding nails). Build a wooden sleeve with the INSIDE dimensions of 26-3/4'' (67. 9cm) in width and 18-7/8'' (47. 9cm) in height. Fill in the space from the opening to the studs with wood spacers, as shown. [. . . ] Cut or build a wall opening in the masonry wall similar to the frame construction (refer to Step 2 of Thru-theWall Installation for a wall thickness greater than 8-1/ 2''). Secure cabinet in place using masonry nails, or the right masonry anchor screws. (Another way to do this is to build an in-between frame of 2x4' as shown in the Step 2 Prepare s Wall illustrations-but make it double framed on either side, and install between masonry wall opening and cabinet. Frame must be securely anchored to masonry wall opening) This way gives very good louver clearance on either side of cabinet. [. . . ]