User manual AEG-ELECTROLUX HBSE 100

[. . . ] You have high standards and expect to purchase quality goods ­ quality offered by Atlas Copco. Please read the instructions for use before first operation so you can handle your power tool effectively and safely. [. . . ] J Always disconnect the plug from the socket before carrying out any work on the machine. J When sanding metal the dust suction facility should not be used, because of the risk of fire from flying sparks. Advice for your safety Typically the A-weighted noise levels of the tool are: Sound pressure level = 91 dB (A). Connect only to a single-phase AC current supply and only to the mains voltage specified on the rating plate. When fitting the plug, make sure that the brown (live) wire of this appliance is connected to the plug terminal marked L or coloured red, and the blue (neutral) wire of this appliance is connected to the plug terminal marked N or coloured black. Under no circumstances must the wires of this appliance be connected to the earth terminal of the plug marked either E, with the earth symbol or coloured green or green/yellow. In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. Always disconnect the plug from the socket before carrying out any work on the machine. Prior the changing belt, adjust sanding belt by turning the belt adjusting screw approx. 2­3 cm in the direction of the open side of the machine beyond the rollers, whilst the machine is running, as the new sanding belt can sometimes brush against the machine housing. Remove the worn belt and fit the inside of Push the clamping lever back again 4. Taking a test run, position the sanding belt With the aid of the belt adjusting screw so that it is flush with the outer edge of the sanding belt support. [. . . ] Endast till enfas-växelström och endast till den nätspänning som finns angiven på effektskylten. We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. [. . . ]