User manual AEG-ELECTROLUX GS60GV220

[. . . ] Obey the safety instructions from the detergent manufacturer to prevent burns to eyes, mouth and throat. Do not use the appliance for other uses to prevent injury to persons and damage to property. Only use the appliance to clean accessories that are applicable for dishwashers. Do not put flammable products or items that are wet with flammable products in, near or on the appliance. [. . . ] Fill the detergent dispenser only before you start a washing programme. When the washing programme starts, a red visual signal shows on the floor below the appliance door. When the washing programme is completed , a green visual signal shows on the floor below the appliance door. When the appliance has a malfunction, a red visual signal flashes on the floor below the appliance door. If the appliance is installed in height, with a flush kitchen furniture door, the visual signal does not show. 1) After you fill the container, the salt indicator can stay on for some hours. This does not have an unwanted effect on the operation of the appliance. 1) When the salt container and/or the rinse aid dispenser are empty, the related indicators do not come on while a washing programme operates. After ten minutes from the end of the washing programme, the AUTO OFF function automatically deactivates the appliance. Press this button again and again to delay the start of the washing programme from 1 to 24 hours. Press one of these buttons again and again to set a washing programme. Each time you press a button, the display shows a number that is related to a washing programme. The dishes can be wet at the end of the programme when you open the appliance door. The appliance must be in setting mode for these operations: · ­ It is necessary to cancel the programme or the delay start to go back to the setting mode. You can hear the acoustic signals in these conditions: · To activate the acoustic signals again, do steps (1) through (7). Be sure that the set level of the water softener agrees with the water hardness in your area. If you use the combi detergent tablets ('3 in 1', '4 in 1', '5 in 1'), use the multitab function (refer to 'Multitab function'). Adjust the level of the water softener if this does not agree with the water hardness in your area. Contact your local water authority to know the water hardness in your area. And you hear five · The display shows the setting of the water softener (example: acoustic signals = level 5). Fill the salt container with 1 litre of water (only for the first time you fill with salt). It is correct that water comes out from the salt container when you fill it with salt. [. . . ] Make sure that an incorrect position of the items do not cause the blockage of the spray arms. The filters are dirty or not asMake sure that the filters are sembled and installed correctly. There are streaks, whitish stains, or a bluish layer on glasses and dishes. The washing programme was without a drying phase or with a decreased drying phase. [. . . ]