User manual AEG-ELECTROLUX GA60SLV221

[. . . ] They must have supervision or instruction for the operation of the appliance by a person who is responsible for their safety. â· Keep children and pets away from the appliance door when it is open. The water inlet hose has a safety valve and a sheath with an inner mains cable. â· If the water inlet hose is damaged, immediately disconnect the mains plug from the mains socket. [. . . ] Level 0 = volume off Factory setting: 1 BRIGHTNESS (10 levels are available). You cannot activate or deactivate this function while a programme operates. If you stop to use the combi detergent tablets, before you start to use separately detergent, rinse aid and dishwasher salt, do these steps: 1. Make sure that the salt container and the rinse aid dispenser are full. Start the shortest programme with a rinsing phase, without detergent and without dishes. Press one of the menu buttons to set a different language and then press OK /Start to confirm. Make sure that the current setting of the water softener agrees with the water hardness in your area. Contact your local water authority to know the water hardness in your area. if you use the combi detergent tablets , activate the multitab function. Be sure that these tablets are applicable to the water hardness in your area. The dishwasher salt keeps the water softener clean and in good conditions. It makes sure that the water softener uses the correct quantity of dishwasher salt and water. When it is necessary to fill the salt container, the display shows the message REFILL SALT . The rinse aid, during the last rinsing phase, helps to dry the dishes without streaks and stains. When it is necessary to fill the rinse aid dispenser, the display shows the message REFILL RINSE AID . Fill the rinse aid dispenser (A), no more than the mark 'max'. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. You can turn the selector of the released quantity (B) between position 1 (lowest quantity) and position 4 (highest quantity). [. . . ] If the holes in the spray arms are clogged, remove remaining parts of soil with a thin pointed object. With some problems, the display shows a message and the Time Beam shows an alarm code. The programme was not ap- Make sure that the proplicable for the type of load gramme is applicable for the and soil. Make sure that the position of the items in the baskets is correct and that the water can easily wash all items. [. . . ]