User manual AEG-ELECTROLUX FD30IMDEN

[. . . ] Grill Assembly Built-In Instructions 5-12 13-15 16-19 17 20 21-22 23 Welcome & Congratulations Congratulations on your purchase of a new gas grill!At Electrolux Home Products, we are very proud of our product and are completely committed to providing you with the best service possible. We know you'll enjoy your new gas grill and Thank You for choosing our product. PLEASE CAREFULLY READ AND SAVE THESE INSTRUCTIONS This Use & Care Manual provides specific operating instruction for your model. [. . . ] Be sure to check on type and size of run, and how deep to bury the line. If the gas supply line is too small, the grill will not operate correctly. Any joint sealant used must be an approved type and be resistant to the actions of L. P. Attach the natural gas regulator (supplied with your grill) to the brass fitting coming out the bottom, backside of the grill (be sure the arrow on the regulator is pointing up towards the grill). Attach your gas line to the 3/8" flare fitting coming out of the natural gas regulator at the back of the grill. Place the installer supplied shut-off valve in an accessible location to enable the gas supply to be cut off to the unit. Gas Installation Frigidaire Gas Grills that are set to operate with L. P. (Note: Only use the pressure regulator and hose assembly supplied with the grill or a replacement pressure regulator and hose assemblies specified by Frigidaire). Attach the gas hose assembly to the brass 3/8 flared fitting using an adjustable wrench on the under side of the grill. cylinder must be provided with a shut-off valve terminating in an L. P. gas supply cylinder outlet specified, as applicable, for connection No. 510 in the standard for compressed gas cylinder valve outlet and inlet connection ANSI/CGA-V-1. Cylinders must not be stored in a building, garage, or any other enclosed area. cylinder must have an overfill protection device, OPD, on it. ) The L. P. Gas supply cylinder must be constructed and marked in accordance with the specifications for L. P. Department of Transportation (DOT) or the National Standard of Canada, CAN/CAS-B339, "Cylinders, Spheres and Tubes for the Transportation of Dangerous Goods. " ·When not in use, gas supply cylinder valve is to be in the "OFF" position. (LP Tank must be kept in an upright position. ) ·The regulator and hose assembly must be inspected before each use of the grill. If there is excessive abrasion or wear or if the hose is cut, it must be replaced prior to the grill being used again. ·Cylinders must be stored outdoors out of the reach of children and must not be stored in a building, garage or any other enclosed area. ·Never fill the cylinder beyond 80% full ·Do not store a spare LP-gas cylinder under or near this appliance 14 Leak Testing General Information Although all gas connections on the grill are leaked tested at the factory prior to shipment, a complete gas tightness check must be performed at the installation site due to possible mishandling in shipment, or excessive pressure unknowingly being applied to the unit. Periodically check the whole system for leaks, or immediately check if the smell of gas is detected. Mix a solution of equal parts mild detergent or liquid soap and water. Testing 1. [. . . ] For removal use an non-abrasive oven cleaner in conjunction with a stainless cleaner. Note: Always scrub in the direction of the grain. Ignitor push button and locking nut Ignitor Access: If the ignitor should ever need to be replaced, there is an access door in the bottom of the front panel, below the ignitor. Fig. A It is opened by removing the two 1/4" hex head screws that hold it in place. (See Fig A) To remove Ignitor, unscrew ignitor push button and locking nut from front panel of grill and ignitor will fall down through opening. [. . . ]