User manual AEG-ELECTROLUX FD26IMDEN

[. . . ] Grill Assembly Built-In Instructions 5-9 10-12 13 14 15 16-17 18 Welcome & Congratulations Congratulations on your purchase of a new gas grill!At Electrolux Home Products, we are very proud of our product and are completely committed to providing you with the best service possible. We know you'll enjoy your new gas grill and Thank You for choosing our product. PLEASE CAREFULLY READ AND SAVE THESE INSTRUCTIONS This Use & Care Manual provides specific operating instruction for your model. [. . . ] All gas connections should be made by a plumber or a gas supply company. For natural gas installation, the supply line must be at least 1/2" diameter. The rotisserie requires a 110/120 volt electric supply and GFI receptacle. The installation of this Grill must conform with local codes, or in the absence of local codes , with National Fuel Code, ANSI Z223. 1a-1998. Installation in Canada must be in accordance with the Standard Can1-b149. 1 and or . 2 (installation code for gas burning appliances and equipment) and local codes. Natural Gas Installation The gas inlet supply pressure should be between 5" and 14" Water Column, (w. c. ) A step down regulator is required if the line pressure is in excess of 14" w. c. Inlet pressure must not exceed 14" water column (1/2 PSIG) Check your local gas utility company or with local codes for instructions on installing gas supply lines. Be sure to check on type and size of run, and how deep to bury the line. If the gas supply line is too small, the grill will not operate correctly. Any joint sealant used must be an approved type and be resistant to the actions of L. P. Attach the natural gas regulator (supplied with your grill) to the brass fitting coming out the bottom, backside of the grill (be sure the arrow on the regulator is pointing up towards the grill). Attach your gas line to the 3/8" flare fitting coming out of the natural gas regulator at the back of the grill. Place the installer supplied shut-off valve in an accessible location to enable the gas supply to be cut off to the unit. Gas Installation Frigidaire Gas Grills that are set to operate with L. P. (Note: Only use the pressure regulator and hose assembly supplied with the grill or a replacement pressure regulator and hose assemblies specified by Frigidaire). Attach the gas hose assembly to the brass 3/8 flared fitting on the under side of the grill. cylinder must be provided with a shut-off valve terminating in an L. P. gas supply cylinder outlet specified, as applicable, for connection No. 510 in the standard for compressed gas cylinder valve outlet and inlet connection ANSI/CGA-V-1. Cylinders must not be stored in a building, garage, or any other enclosed area. Gas supply cylinder must be constructed and marked in accordance with the specifications for L. P. Department of Transportation (DOT) or the National Standard of Canada, CAN/CAS-B339, "Cylinders, Spheres and Tubes for the Transportation of Dangerous Goods. " ·When not in use, gas supply cylinder valve is to be in the "OFF" position. [. . . ] If the grill is allowed to cool down, cleaning the grates will be easier if removed from the grill and cleaned with a mild detergent. After initial usage, areas of the grill may discolor from the intense heat given off by the burners, this is normal. Purchase a mild stainless steel cleaner and rub in the direction of the grain of the metal. Specks of grease can gather on the surface of the stainless steel and bake on to the surface and give a worn appearance. [. . . ]