User manual AEG-ELECTROLUX FAVORIT 35020 VI

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. Operating instructions Safety information Correct use General safety Child safety Installation Product description Control panel Setting mode Audible signals First use Set the water softener Setting manually Setting electronically Use of dishwasher salt Use of rinse aid Adjusting the dosage of rinse aid Daily use 3 3 3 3 3 4 4 5 5 6 6 7 7 8 8 9 10 10 Select and start a washing programme 18 Setting and cancelling the delay start of a washing programme 18 Unloading the dishwasher 19 Care and cleaning 19 Cleaning the filters 19 Cleaning the spray arms 20 External cleaning 20 Internal cleaning 20 Prolonged periods of non-operation 20 Frost precautions 21 Moving the machine 21 What to do if. [. . . ] ) must be loaded in the upper basket and arranged so they do not move. In this case the rinse aid indicator light will always remain illuminated when the machine is switched on (not all dishwasher models are foreseen with rinse aid indicator light). If you decide to turn back to the use of the standard detergent system we advise that you: Adjust the water hardness setting to the highest setting and perform washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. 1) The consumption values are intended as a guide and depends on the pressure and the temperature of the water and also by the variations of the power supply and the amount of dishes. This is the perfect daily programme, made to meet the needs of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery. 4) This programme does not require the use of detergent Press the programme selection/RESET button until the light corresponding to the required washing programme illuminates (see "Washing programmes" chart). The washing programme will start automatically when 3 hours have elapsed. Close the door; the programme will start from the point at which it was interrupted. cancel a washing programme in progress · Open the dishwasher door; press the programme selection/RESET button for about 3 seconds, until the light of the running programme turns off and the end of programme indicator light flashes. If a new washing programme is to be selected, check that there is detergent in the detergent dispenser. Leave the dishwasher door ajar and wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. The dishes should therefore be allowed to cool down before removing from the appliance. ⷠEmpty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. ⷠWater may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. Turn the handle about 1/4 a turn anticlockwise and remove the filter system. Take hold of the coarse filter (A) by the handle with the hole and remove from the microfilter (B). Remove the flat filter from the base of the washing compartment and clean both faces thoroughly. Put the flat filter back in the base of the washing compartment and ensure that it fits perfectly under the two guides (C). Put the filter combination in place and lock by turning the handle clockwise to the stop. During this process ensure that the flat filter does not protrude above the base of the washing compartment. [. . . ] If the water inlet hose starts to leak during this operation, the safety valve cuts off the running water. Please take care when installing the water inlet hose: · the electrical cable for the safety valve is in the double-walled water inlet hose. A water inlet hose with safety valve must only be replaced by a specialist or by the Service Force Centre. to the sink outlet spigot , securing it to the underside of the work surface. [. . . ]