User manual AEG-ELECTROLUX F88030VIP

[. . . ] Load cutlery and dishes 44 The lower basket 45 The cutlery basket 45 Beer glasses 47 The upper basket 48 Adjusting the height of the upper basket 49 Use of detergent 50 Fill with detergent 50 Multitab function 51 Subject to change without notice In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. This dishwasher is only intended for washing household utensils suitable for machine washing. [. . . ] Place knives, small spoons and small forks in the cutlery tray which is in the upper basket. place forks and spoons that do not fit in the cutlery tray in the cutlery basket. To ensure that all items of cutlery in the cutlery basket can be reached by the water, you should: The cutlery basket can be opened out. Always make sure that you put your hand around both parts of the two-part handle when removing it from the dishwasher. There are the glass holders on the left hand side in the lower basket. You can use them as: · Pull upwards and push lightly on the hooks from below. Load cutlery and dishes You can remove the support that fix the beer glass holders or cup racks if necessary. Arrange items of crockery on and under the folding cup racks so that they are offset from each other and water can reach all items. The cup racks can be folded up out of the way for tall crockery items. With the selection of this function the inflow of rinse aid and salt from each respective supply container is automatically deactivated and also the indicator lights for salt and rinse aid are deactivated. select the "Multitab function " before the start of a washing programme. The start of the selected washing programme can be delayed for between 1 and 19 hours. Close the door; the countdown will continue from the point at which it was interrupted. Simultaneously press and hold the two programme buttons positioned over the word RESET, until 2 horizontal lines will appear in the digital display. If a new washing programme is to be selected, check that there is detergent in the detergent dispenser. Close the door, the programme will start from the point at which it was interrupted. It is recommended to switch off the appliance once the washing programme has ended. If this is not done, automatically after about 3 minutes from the end of the programme, all indicator lights will go off. This will help to reduce the consumption of energy when you forget or for any reason cannot switch the appliance off once the programme has ended. Press any button (except On/Off) and the control panel will show the same situation (indicator lights and digital display) as when the programme ended. Leave the dishwasher door ajar and wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. The dishes should therefore be allowed to cool down before removing from the appliance. [. . . ] After connecting the double-walled water inlet hose, the safety valve is next to the tap. Therefore the water inlet hose is only under pressure while the water is running. If the water inlet hose starts to leak during this operation, the safety valve cuts off the running water. Please take care when installing the water inlet hose: · the electrical cable for the safety valve is in the double-walled water inlet hose. [. . . ]