User manual AEG-ELECTROLUX F36WC19EEN

[. . . ] Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction codes and standards. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent backdrafting. [. . . ] 5 PREPARING THE INSTALLATION LOCATION NOTE MOUNT HOOD SO THAT BOTTOM OF HOOD IS 18"-24" ABOVE COOKING SURFACE. IF DISTANCE BETWEEN WALL AND FRONT OF CABINET FRAME IS MORE THAN 12" THERE WILL BE A SPACE BETWEEN BACK OF HOOD AND WALL. OMIT STEP 9 if range hood will be installed under cabinets with flush bottom. (For installation on recessed bottom cabinets only) Attach a wood filler strip at each side of recessed area under cabinet. (Use two 1" x 2" strips cut to length. ) If recess is more than 1" use thicker strips. 7 & 8): a) Electrical line opening b) Duct opening 11. Drill four pilot holes in corners of marked duct opening as shown and cut opening with saber saw or keyhole saw. 12. Use 1-1/4" drill bit to drill opening for electrical connection in wall or cabinet. 13. Hold hood up against cabinet bottom and trace keyhole slots onto cabinet bottom of filler strips. 14. Screw the four supplied 7/8" wood screws for mounting the hood into the exact center of the narrow end of the keyhole slots marked underneath the cabinet. Allow 3/8" of the screws to project, so the hood can be fitted into place. FIG. 7 CUT STRIPS TO FIT 3 DUCT CENTER OPENINGS LINE WIDTH OF RANGE ELECTRICAL HOOD WIRING OPENING INSTALLING THE DUCTWORK NOTE THESE INSTRUCTIONS WILL FOLLOW THE PLANS MADE ON PAGE 2. FOR BEST PERFORMANCE OF YOUR RANGE HOOD, USE THE SHORTEST POSSIBLE DUCT RUN AND A MINIMUM NUMBER OF ELBOWS. NEVER VENT A RANGE HOOD INTO AN ATTIC SPACE BECAUSE A BUILDUP OF GREASE WILL BECOME A FIRE HAZARD. ASSEMBLE SECURELY SO THAT IN CASE OF A GREASE FIRE ON THE RANGE, THE FIRE WILL BE CONTAINED INSIDE METAL DUCT WORK. IT IS A GOOD PRACTICE TO TAPE ALL DUCT CONNECTIONS, MAKING THEM BOTH SECURE AND AIR TIGHT. 15. Follow appropriate directions below for type of duct work you are installing: WALL CAPS (FIG. 9) Use a saber saw to cut a hole slightly larger than duct so duct will line up easily with hood. Fasten wall cap to last section of duct and nail or screw cap to wall. Make sure that enough duct runs into the room so that the duct will overlap the damper/duct connector by 3/4" when the hood is installed. ROOF CAPS Cut hole in roof slightly larger than duct so duct will line up easily with hood. Trim shingles around hole so that they will fit snugly around hood of cap when cap is installed. Trim duct parallel to roof pitch, leaving 3/4" of duct projecting above roof. [. . . ] If You Need Service Keep your receipt, delivery slip, or some other appropriate payment record to establish the warranty period should service be required. If service is performed, it is in your best interest to obtain and keep all receipts. Service under this warranty must be obtained by contacting Electrolux at the addresses or phone numbers below. This warranty only applies in the USA and Canada. In the USA, your appliance is warranted by Electrolux Major Appliances North America, a division of Electrolux Home Products, Inc. [. . . ]