User manual AEG-ELECTROLUX ETN1021H

[. . . ] · Children should be supervised to ensure that they do not play with the appliance. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service centre before using. · Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. · Do not use extension cords or outlets with inadequate current carrying capacity. [. . . ] If there is any sign of damage to the supply cable it MUST be renewed. The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13 amp socket in another part of your home. The wires in the mains cable of this appliance are coloured in accordance with the following code: Blue: Neutral. As the colours of the wires in the mains cable of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. If using a three-pin plug, do not make any connection to the terminal marked with the letter E or by the earth symbol or coloured green or green-andyellow. This cleaner is double insulated and no earth connection is necessary. It is in your interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, consult a qualified electrician, as Electrolux cannot regard the repair of faults on the plug connection as a service that can be given free of charge under the terms of the guarantee. Fuse Cover 13 Amp Fuse E N Fuse Blue L Brown Cord Clamp The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. On models with extension cords, plug extension cord into the pigtail connection. Secure the cord assembly into the retainers on the back of the handle. On models with direct wire cords, insert the cord around the three retaining tabs on the back of the handle. To store the power cord, lift out the lower cord hook and wrap the cord around the upper (11) and lower cord hooks (12). The lower cord hook can be stored flat on the cleaner when not in use. The power cord can be quickly released by pivoting the upper cord hook downward. Return the upper cord hook to the upright position for cord storage. 6. On models with cleaning attachments, place the wand into the lower retainer. 16. Lower Wand Retainer Suction Selection Valve Extension Wand and Dusting Brush Wand Clip Upper Cord Hook Lower Cord Hook Cleaning Height Adjustment Brush Roll Indicator and Reset HEPA Filter Assembly Filter Latch 5 How to Use 2. Carpet 4. Bare Floors 1. Recommended Settings Example of Carpet Position 1 Position 2 Position 3 Position 4 Hard Floors Low Pile Medium Pile High Pile 3. 7. 5. 6. 8. 9. 10. lowest setting for maximum cleaning. If during use, the cleaner is difficult to push, move the adjustment to the next height setting until the cleaner is comfortable to push. [. . . ] The cleaner will automatically shut off the brush roll motor if the brush roll stalls. This will be indicated by a red light on the base near the handle release. To reset the motor, clear any obstruction to the brush roll and press the reset switch. HOW TO SERVICE THE BRUSH ROLL (BELT CODE ZE107) HOW TO REPLACE THE HEPA FILTER ASSEMBLY (FILTER CODE EF107) 3. Install new filter by aligning the tabs at the bottom of the filter with the slots on the exhaust area of the cleaner and snap into place. [. . . ]