User manual AEG-ELECTROLUX ESI6261K

[. . . ] Good luck! 4 electrolux contents Contents Safety information Product description Control panel First use Daily use Washing programmes Care and cleaning Something not working Technical data Hints for test institutes Installation Environment concerns Guarantee/Customer Service 5 7 8 11 15 28 29 31 34 36 37 41 42 The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information safety information electrolux 5 Safety information q In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] Press button 2, the lights of buttons 1 and 3 turn off while the light of button 2 goes on flashing. To change the setting, press button 2 again, the digital display indicates the new setting. Rinse aid dispenser deactivated Rinse aid dispenser activated daily use electrolux 25 Select and start a washing programme 2. Close the dishwasher door, the countdown starts automatically and the number in the display stops flashing. Close the door; the countdown will continue from the point at which it was interrupted. Once the delay start has elapsed the programme will start automatically. Select the washing programme and delay start with the door slightly opened. The start of the programme or the countdown of the delay start will occur only after the closure of the door. Check that the baskets have been loaded correctly and that the spray arms are free to rotate 2. Press the button corresponding to the required programme (see "Washing programmes" chart). When a programme has been selected the corresponding light will illuminate. After having selected the washing programme, press the delay start button until the flashing number of hours for the delay start will appear in the digital display. Remove the flat filter from the base of the washing compartment and clean both faces thoroughly. Before cleaning the filters ensure that the machine is switched off. 1. The dishwasher filter system comprises a coarse filter (A), a microfilter (B) and a flat filter. Put the flat filter back in the base of the washing compartment and ensure that it fits perfectly. Place the coarse filter (A) in the microfilter (B) and press together. Put the filter combination in place and lock by turning the handle clockwise to the stop. During this process ensure that the flat filter does not protrude above the base of the washing compartment. 3. Turn the handle about 1/4 a turn anticlockwise and remove the filter system. NEVER use the dishwasher without filters. Incorrect repositioning and fitting of the filters will produce poor washing results and may result in damage to the appliance. 30 electrolux care and cleaning NEVER try to remove the spray arms. If residues of soil have clogged the holes in the spray arms, remove them with a cocktail stick. Frost precautions Avoid placing the machine in a location where the temperature is below 0C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. [. . . ] Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided. When connecting the drain hose to an under sink trap spigot, the entire plastic membrane (A) must be removed. Failure to remove all the membrane will result in food particles building up over time eventually blocking the dishwasher drain hose spigot Our appliances are supplied with a security device to protect against the return of dirty water back into the machine. If the spigot of your sink has a "no return valve" incorporated this can prevent the correct draining of your dishwasher. We therefore advise you to remove it. 40 electrolux installation Electrical connection Safety standards require the appliance to be earthed. [. . . ]