User manual AEG-ELECTROLUX ESF6520LGW

[. . . ] Isolate the appliance from the power supply and turn off the water supply after use. Care should be taken when cleaning the bottom door seal and hinge area as any exposed metal edges may cut if care is not taken. This product should be serviced by an authorised Service engineer, and only genuine spare parts should be used. Under no circumstances should you attempt to repair the machine yourself. [. . . ] Arrange items on and underneath the cup racks so that water can reach all surfaces. Light items (plastic bowls etc. ) should be loaded in the upper basket and arranged so they do not move. In case that plates are loaded in the upper basket: load them starting from the rear positions of the basket, tilting them slightly forwards and avoiding the front positions near the door. US64 US71 Before closing the door, ensure that the spray arms can rotate freely. Adjusting the height of the upper basket If washing very large plates (over 27 cm and up to 32 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position. Move the front runner stop (A) of the upper basket outwards and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. A RC01 When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the raised cup racks. After loading your machine always close the door, as an open door can be a hazard. 11 Use of detergent Only use detergents specifically designed for use in dishwashers. Add the detergent according to the instructions given in the Washing programmes chart. As all detergents are not the same, you should also consult the instructions on the packet. If the programme has a prewash add the required detergent over the lid of the dispenser. Follow the recommended quantity of detergent given in the Washing programmes chart. If using detergent in tablets proceed as follows: M M IN AX Min = 15 g Max = 30 g D 1. Tilt items with convex or concave surfaces so that the water drains off easily. Press the DELAY START push button and selected the desired time (3, 6 or 9 hours) until the indicator light corresponding to the chosen hours flashes. Press the push button corresponding to the wanted programme: the indicator light corresponding to the programme illuminates and the phase indicator lights foreseen for that programme start flashing. The start of the countdown will occur after about 6 seconds from the last pressure of a push button. The countdown will decrease with step of 3 hours and you are informed of this by the indicator lights of the hours. 7. Close the dishwasher door 15 During the countdown the only indicator lights illuminate are the programme light and the light of the number of hours to the start of the programme. Once the delayed time has elapsed the programme will start automatically. It is possible to stop a countdown in progress or before it starts, simply pressing the DELAY START push button until the indicator lights of the hours are off: Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. 9. To cancel a programme in progress A programme in progress can be cancelled at any time. Press for about 3 seconds the push button of the running programme until all indicator lights are off. Only the ON-OFF indicator light will remain on once the programme has been cancelled. In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops. [. . . ] For making the connection itself, the coupling nut fitted to the machine's supply hose is designed to screw onto either a 3/4 inch gas thread spout, or to a purpose made quick-coupling tap such as the Pressblock. The water supply hose is fitted with a safety device, which prevents water from entering the machine should the inner hose split, due to wear. The problem is signalled by a red indicator which appears in the window (B - ). The retaining ring (A - ) must be properly fitted so as to avoid water leaks. [. . . ]