User manual AEG-ELECTROLUX ESF6111

[. . . ] Isolate the appliance from the power supply and turn off the water supply after use. Care should be taken when cleaning the bottom door seal and hinge area as any exposed metal edges may cut if care is not taken. This product should be serviced by an authorised Service engineer, and only genuine spare parts should be used. Under no circumstances should you attempt to repair the machine yourself. [. . . ] Arrange items on and underneath the fold-down cup racks so that water can reach all surfaces. The cup rack on the left folds upwards to increase your loading flexibility. Light items (plastic bowls etc. ) should be loaded in the upper basket and arranged so they do not move. US07 Before closing the door, ensure that the spray arms can rotate freely. Adjusting the height of the upper basket If washing very large plates (over 27 cm and up to 31 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position. Move the front runner stops (A) of the upper basket outward and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the raised cup racks. A RC01 After loading your machine always close the door, as an open door can be a hazard. 9 Use of detergent Only use detergents specifically designed for use in dishwashers. Add the detergent according to the recommended quantity given in the "Washing programmes" chart. As all detergents are not the same, you should consult the instructions on the packet. If the programme has a prewash add the required detergent over the lid of the dispenser. Follow the recommended quantity of detergent given in the "Washing programmes" chart. Min = 15 g Max = 30 g D DE17 If using detergent in tablets proceed as follows: 1. For all programmes with prewash; place a portion of a further tablet on the lid of the detergent dispenser. DE02 Insufficient quantities of detergent will produce poor washing results, whereas an excessive amount of detergent will not improve washing results and is also wasteful. The dishwasher filter system comprises a coarse/fine filter, microfilter and a flat filter. Unlock the filter system using a handle on the microfilter, and remove. Take hold of the coarse/fine filter (1/2) by the handle with the hole and remove from the microfilter (3). Remove the flat filter (4) from the base of the washing compartment and clean both faces thoroughly. Put the filter combination in place and lock by turning the handle clockwise to the stop. During this process ensure that the flat filter does not protrude above the base of the washing compartment. MA17 MA15 3. Incorrect repositioning and fitting of the filters will produce poor washing results. Cleaning the filters is vital to ensure correct operation of the machine. MA16 4 14 External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: 1. Leave the door ajar to prevent the formation of any unpleasant smells. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. [. . . ] Be sure to incorporate the filter (A) supplied with the machine onto the joint. For making the connection itself, the coupling nut fitted to the machine's supply hose is designed to screw onto either a 3/4" inch gas thread spout, or to a purpose made quick-coupling tap such as the Pressblock. 19 A CA02 Water outlet hose connection The end of the drain hose can be connected in the following ways: 1. Hooked over the edge of the sink using the special curved plastic guide provided. To a stand pipe provided with vent-hole, minimum internal diameter 4 cm. CS09 Ø 18 max 100 cm The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. Ø 18 Ø 21 The drain hose can face either to the right or left of the dishwasher Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water. [. . . ]