User manual AEG-ELECTROLUX EHG 30230

[. . . ] ⷠDo not let the liquids overflow into the holes of the top of the hob · Do not use the hob without cookware. Use only cookware with diameter applicable to the dimensions of burners. There is a risk of overheating and rupture of the glass plate (if applicable). ⷠDo not use a pan with diameter smaller than burner dimension - flames will heat up the pan handle. [. . . ] Choose fixed connections or use a flexible pipe in AGB (stainless steel) in compliance with the regulation in force. If you use flexible metallic pipes, be careful they do not come in touch with mobile parts or they are not squeezed. Make sure that the gas supply pressure of the appliance obeys the recommended values. The adjustable connection is fixed to the comprehensive ramp by means of a threaded nut G 1/2". All the components shown in the figure have already been assembled in the factory. The appliance, before leaving the factory, has been tested in order to give you the best results. 1 End of shaft with nut 2 Washer 3 Elbow Liquid gas: use the rubber pipe holder. The flexible pipe is prepared for apply when: ­ it can not get hot more than room temperature, higher than 30°C; ­ it is no longer than 1500 mm; ­ it shows no throttles; ­ it is not subject to traction or torsion; ­ it does not get in touch with cutting edges or corners; ­ it can be easily examined in order to check its condition. ­ it does not show cracks, cuts, marks of burnings on the two ends and on its full length; ­ the material is not hardened, but shows its correct elasticity; ­ the fastening clamps are not rusted; ­ expired term is not due. If one or more defects are visible, do not repair the pipe, but replace it. When installation is complete, make sure that the seal of each pipe fitting is correct. With a socket spanner 7 remove the injectors and replace them with the ones which are necessary for the type of gas you use (see table in Technical Data section). Replace the rating plate (it is near the gas supply pipe) with the one for the new type of gas supply. If the supply gas pressure is changeable or different from the necessary pressure, you must fit an applicable pressure adjuster on the gas supply pipe. Adjustment of minimum level To adjust the minimum level of the burners (only for Belgium): 1. ­ If you change from natural gas to liquid gas, fully tighten the adjustment screw in. ­ If you change from liquid gas to natural gas, undo the by-pass screw approximately 1/4 of a turn. Make sure the flame does not go out when you quickly turn the knob from the maximum position to the minimum position. electrical connection · Ground the appliance according to safety precautions. ⷠMake sure that the rated voltage and type of power on the rating plate agree with the voltage and the power of the local power supply. It has to be supplied with a correct plug, able to support the load marked on the rating plate. Any electrical component must be installed or replaced by the Service Force Centre technician or qualified service personnel. [. . . ] 1 Stick it on Guarantee Card and send this part 2 Stick it on Guarantee Card and keep this part 3 Stick it on instruction booklet These data are necessary to help you quickly and correctly. They are available at Service Force Centre and approved spare parts shops. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. [. . . ]