User manual AEG-ELECTROLUX EFP643S

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual AEG-ELECTROLUX EFP643S. We hope that this AEG-ELECTROLUX EFP643S user guide will be useful to you.


AEG-ELECTROLUX EFP643S : Download the complete user guide (2010 Ko)

You may also download the following manuals related to this product:

   AEG-ELECTROLUX EFP643S (1913 ko)
   AEG-ELECTROLUX EFP643S (1600 ko)

Manual abstract: user guide AEG-ELECTROLUX EFP643S

Detailed instructions for use are in the User's Guide.

[. . . ] The electrical power supply to the hob is only cut off when the power supply cable is unplugged or the fuse is disconnected. The laws and regulations applicable to the method used for the vented air outlet must be observed. For example, the exhaust air must not be vented towards ducts used for combustion flue gases, powered by a type of energy other than electricity, such as fuel-oil boilers and wood-fired stoves. Scrapping When scrapping the hood, take all the necessary steps set forth by the law to prevent all future accidents. Unplug the plug on the power supply cable from the wall socket and cut the cable near the appliance air inlet. [. . . ] By re-circulating the air, using a charcoal filter (filter sold separately). The hood must not be connected to a flue duct used for the flue gases originating from appliances that do not run on electricity. The charcoal filter purifies the air that circulates throughout the hood; this hot air is then re-introduced into the appliance in order to avoid all energy wastage. It is preferable to use the re-circulation mode in winter and the vented mode in summer. 33 Hood Use Turning off the hood Press the fan switch for at least 3 seconds. The fan motor is consequently turned off but the light continues to operate normally. To turn on the hood, push the visor first slightly inwards and then pull it out completely. Speed control The extractor fan speed can be adjusted using the pull-out glass visor (see figure). Correct ventilation For the hood to operate correctly, do not open any windows in your kitchen; on the other hand, you should open a window in the next room. B Important recommendation If the hood operates at the same time as a burner or open fire (gas, fuel-oil or wood-fired heating, water heater, etc. ), take special care because the hood may intake the air necessary for the combustion of said systems. Only use high speeds to evacuate strong odours (such as those generated by burnt food, etc. ). A Pushbutton A (Timer) When the glass visor is in position (A), the light turns on. When the adjuster reaches position (B), the hood motor starts at low speed, then the speed increases gradually as the panel is pulled out. To set the intensive speed, then push the push button A (see figure), the intensive speed lasts for 5 minutes. For best results, low speeds are recommended under normal operating conditions, and higher speed settings when the concentration of fumes and steam are highest. Turn the hood on a few minutes before you begin cooking, in order to create a partial vacuum in the kitchen. If the problem persists, contact your retailer or our after-sales service centre. Power supply cable replacement If the hood power supply cable is damaged, it should be replaced by a qualified serviceman. Repairs and spare parts Please contact your retailer for all repair work and spare parts. Before calling our after-sales service centre, note the appliance serial number and the model name. Remove the grease filter to access the data plate. 36 Technical Specifications Model Dimensions Height Width Depth Lighting Grease filter Electrical connection (Electric) Safety class Maximum absorbed power 460 mm 596 mm 315 mm max 2 x 20 W 1 230 V I 310 W 460 mm 596 mm 320 mm max 2 x 20 W 1 230 V I 310 W EFP 6446 EFP 6456 95 17 8 120 70 14 0 430 460 596 300 20185 -34 5 EFP 6456 95 17 13 120 70 14 0 430 460 596 15- 180 300 -34 5 EFP 6446 37 Installation Unpacking Make sure the hood is in perfect condition. The carrier must be notified immediately of any damage incurred during transportation. The retailer must be notified immediately of any damages, faults and any missing parts. Do not leave the packaging components within the reach of children. Positioning The hood must be installed in a wall cabinet. This would affect its positioning and could cause the hood to become noisy. The hood must be installed at a minimum of 40 cm above an electric hob or cooker and at least 65 cm above gas burners or a gas cooker (see figure). Min 40 cm Min 65 cm Installing the hood in a cabinet The locking screws must be in place (x 2). Trace a line using the installation template to guide you (see figure 1). Saw along this line and cut a groove at the base of the top part of the cabinet. Install the suspension bars (see figure 2) on the installation template. [. . . ] If the hood is to be installed at a height above that of the cabinet base: 1. Use the installation template to trace two vertical lines on either side (see figure 2). Install the locking screw (see "Installing the hood in a cabinet", figure 4). 1. 2. 3. Electrical connection The electricity socket must be situated above the hood, inside a wall cabinet. The hood is supplied with an electrical power supply cable fitted with a moulded plug with an earthing pin, suitable for a 230 V wall socket. Depth adjustment Once the hood has been installed, adjust it so that it is in line with the wall. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE AEG-ELECTROLUX EFP643S




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual AEG-ELECTROLUX EFP643S will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.