User manual AEG-ELECTROLUX DSE 220

[. . . ] S Please pay attention to the safety instructions in the attached leaflet!S Do not pierce the motor housing as this could damage the double insulation (use adhesives). S Always disconnect the plug from the socket before carrying out any work on the machine. [. . . ] The detail sander can be used for sanding a large variety of surfaces, especially in corners and on edges, as well as in confined areas. Brief description Infinitely variable electronic speed pre-selection for working a large variety of surfaces. In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. Connect only to a single-phase AC current supply and only to the mains voltage specified on the rating plate. When fitting the plug, make sure that the brown (live) wire of this appliance is connected to the plug terminal marked L or coloured red, and the blue (neutral) wire of this appliance is connected to the plug terminal marked N or coloured black. Under no circumstances must the wires of this appliance be connected to the earth terminal of the plug marked either E, with the earth symbol, or coloured green or green/yellow. Due to the electronic the speed can be controlled by setting the wheel to suit the various materials. Always disconnect the plug from the socket before carrying out any work on the machine. 15°) to the tool reception (as shown in illustration) and turn it in direction of arrow until it locks. To remove the base plate depress the locking button and remove the base plate from the reception by turning it. Should the Velcro coat at the top of the base plate be worn after longer use, the base plate can be turned 120° and be re-mounted. Always disconnect the plug from the socket before carrying out any work on the machine. The holes in the sandpaper must conform with the holes in the base plate. When producing large quantities of dust, a suction hose (35 mm diameter) can be connected via the provided adapter. [. . . ] The exchange of components not described must be carried out from an Atlas Copco service agent (refer to the leaflet guarantee/service agents). As well as the machine type printed on the label and order the drawing at your local service agents or directly at: Atlas Copco Electric Tools GmbH, Postfach 320, D-71361 Winnenden. S Se till att maskinen är frånkopplad innan den anslutes till nätet. [. . . ]