User manual AEG-ELECTROLUX DI9610M-R

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual AEG-ELECTROLUX DI9610M-R. We hope that this AEG-ELECTROLUX DI9610M-R user guide will be useful to you.


AEG-ELECTROLUX DI9610M-R : Download the complete user guide (716 Ko)

You may also download the following manuals related to this product:

   AEG-ELECTROLUX DI9610M-R (710 ko)
   AEG-ELECTROLUX DI9610M-R (708 ko)
   AEG-ELECTROLUX DI9610M-R (762 ko)

Manual abstract: user guide AEG-ELECTROLUX DI9610M-R

Detailed instructions for use are in the User's Guide.

[. . . ] The minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of the range hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. Before any cleaning or maintenance operation, disconnect the hood from the mains by removing the plug or disconnecting the home mains switch. The appliance is not intended for use by children or persons with impaired physical, sensorial or mental faculties, or if lacking in experience or know-how, unless they are under supervision or have been trained in the use of the appliance by a person responsible for their safety. [. . . ] Self-Timer ON/OFF: times all the speed levels (the dot "a" on display is flashing), and then the cooker hood switches off: The self-timer is set as follows: 1st speed level 20 minutes 2nd speed level 15 minutes 3rd speed level 10 minutes The display shows the remaining operation time, at the end of the time an acoustic signal is heard. Display Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds. After reconnecting the power supply wait 15 seconds and then check that the cooker hood is now operating correctly. This hood is fitted with a device that indicates when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter). On delivery, the hood is not supplied with a charcoal filter, so the saturation indicator will be disabled. If the hood is to be used with a charcoal filter, the saturation indicator light must be enabled as follows: Set in "OFF" the hood. At first only the grease filter LED F will light up, but when the charcoal filter LED C lights up the saturation indicator will be enabled. To disable it: Press buttons 3 and 4 again simultaneously and hold them for 3 seconds, until the charcoal filter LED goes out. Always comply with the maintenance instructions for the grease filter. The charcoal filter LED C will start to flash when the charcoal filter needs to be replaced. After cleaning or replacing the filters, press button 3 for 3 seconds until the grease filter LED F or the charcoal filter LED C stops flashing. Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the rating plate located on the inside of the unit. The charcoal filter can be ordered from your local Service Force Centre. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Extract the lamp cover by using a small flat screwdriver or similar tool as a lever. If the light does not come on, make sure the bulb has been inserted in correctly before contacting your local Service Force Centre. Clean the outside of the hood using a damp cloth and a solution of water and mild washing up liquid. Only ever clean the switch panel and filter grill using a damp cloth and mild washing up liquid. Clean all the plastic parts with a soft cloth soaked in warm water and neutral soap. It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard. [. . . ] Fit the extension brackets B to the perforated frame using 4 screws for each, so that the perforated frame can be extended to the calculated length E. For perforated frame extensions (please refer to measurement E calculated previously): - smaller than 690 mm: this extension requires only one bracket (C1); generally this is already fixed in place. - greater than 800 mm: fit all available reinforcement brackets (2 x C1 + 1 x C2) Use 8 screws to fix each reinforcement bracket in place. Note: One of the two C1 brackets is usually already fitted when the appliance is supplied. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE AEG-ELECTROLUX DI9610M-R




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual AEG-ELECTROLUX DI9610M-R will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.