User manual AEG-ELECTROLUX BS 12 C IQ

[. . . ] EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. MAINTENANCE If the supply cord of this appliance is damaged, it must only be replaced by a repair shop appointed by the manufacturer, because special purpose tools are required Use only AEG accessories and spare parts. Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/ service addresses). [. . . ] As soon as charging is completed, the charger switches over to "trickle" charge to maintain the full capacity (green control lamp is illuminated continuously) It is not necessary to remove the battery after charging. The battery can be stored permanently in the charger without the danger of being overcharged. If both LEDs flash at the same time, either the battery has not been completely mounted or there is a fault in the battery or the charger. For safety reasons you must stop using the charger and battery immediately and have them inspected by an AEG Customer Service Centre. *1Measured according to AEG norm N 877318 *2 The values stated are reference values. WARNING The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. the declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. The following battery packs can be charged with this charger: voltage battery rating No. Of (of storage battery) battery cells 12 V L1215 <=1, 5 Ah 3 Do not try to charge non-chargeable batteries with this charger. No metal parts must be allowed to enter the battery section of the charger (short circuit risk). Never break open battery packs and chargers and store only in dry rooms. Before use check machine, cable, and plug for any damages or material fatigue. This appliance is not intended for use by persons (including children) with limited physical, sensory or mental capabilities or insufficient experience and/or knowledge unless they are supervised by a person who is responsible for their safety or have been instructed by them in the safe use of the tool. [. . . ] use only System PCLS chargers for charging System PCLS battery packs. Battery acid may leak from damaged batteries under extreme load or extreme temperatures. In case of contact with battery acid wash it off immediately with soap and water. [. . . ]