User manual AEG-ELECTROLUX AEG 76760

[. . . ] ÖKO-LAVAMAT 76760 update The environmentally friendly washing machine User information Dear Customer, Please read this user information carefully. Pay particular attention to the section "Safety" on the first Info pages. Please keep this user information in a safe place for later reference. Pass it on to any future owners of the unit. 1 The warning triangle and /or signal words (Warning!, Caution!, Important!) emphasise information which is important for your safety or for the unit's functional reliability. [. . . ] If the fault code is displayed again, please contact the Customer Service department quoting the fault code. Problem Possible Cause The mains plug is not plugged in. Press the button START/ PAUSE until the program starts. Cancel the child safety feaThe filling door cannot The child safety feature is set ture (see Section "Child be closed. PRE WASH, RINSE and RINSE+ flash. Close the filling door correctly. Restart the program. 32 Operating Instructions Problem Possible Cause Water tap closed. Filter in screw connection of the hose from the tap, remove the sieve and clean unError code (1 is shown the intake hose blocked. Remove transport packaging according to the installation and connection instructions. Adjust the feet in accordance with the installation and connection instructions. The washing machine There is not much washing in This does not impair the vibrates during opera- the drum (e. g. Check the laying of the The water could not be comdrainage hose and eliminate pletely pumped off before the bend if necessary, or spinning because clean the drain pump and, if The drainage hose is bent required, remove foreign or bodies from the pump housThe drain pump is blocked. Meter the detergent exactly in accordance with the manufacturer's information. 33 Operating Instructions Problem Possible Cause Remedy The screw connection on the Tighten the intake hose intake hose is leaky. Close the emergency drainage hose correctly (see the section "Carry out emergency drainage"). Turn off the tap, then remove the plug from the mains and inform Customer Service. The emergency drainage hose is not correctly closed or leaks. The drain pump for the washing machine runs The Aqua Control anti-flood constantly - even when system has been activated. Conditioner was not washed in, compartment æ for care agents is filled with water. The conditioner insert in the Clean the detergent drawer, compartment for care agents attach the conditioner insert is not correctly attached or securely. In the case of easy-care textiles, select the program EASY IRON. Washing heavily creased. Too mush washing probably put in. The washing has not been spun as dry as usual. Always load the drum The washing was not able to as ful as possible with a combe distributed evenly in the bination of large and small drum prior to spinning. items. 34 Operating Instructions Problem Possible Cause Drainage hose bent. Remedy Remove the bend. Contact your customer servMaximum pumping height ice. For pumping heights (discharge height 1m from over lm he can offer you a Washing is not well the unit's standing surface) is conversion kit as a special spun. Error code (2 is shown Switch off the unit and pull in the multi-display. Should it nevertheless be necessary to open the main The filling door is locked be- door: cause of a high water level or Turn the programme knob to a high temperature. The main door can be opened afThe main door cannot ter the water has been be opened while the pumped out. If water can be seen through the window in the door, first carry out emergency emptying (see section "Carrying out Emergency Emptying Operation"). Unscrew the inlet hose from the water tap and from the unit and clean the filter. Power failure!(All indicators have gone off. ) For safety reasons the door remains locked for 4 to 10 minutes. Water tap not fully opened. [. . . ] Domaniewska 41 02-034 Warszawa tel. : 022 874 33 33 fax: 022 874 33 00 Russia Electrolux Russia Ltd. 16 Olympiysky prospekt 129090 Moscow Tel. : (095) 937 7837 Fax: (095) 926 5513 53 Warranty conditions / Customer service centres Israel Electricity & Electronic Services-Evis LTD. Raanana, Industrial area 43654 Tel: 972-9-7448118 Fax: 972-9-7603618 e-mail:evis@evis. co. il Malaysia Arzbergh Engineering No. 49A/B, Jalan Petaling Utama 7 4600 Petaling Jaya Tel. : 3 795 1084 Fax: 3 795 1082 Saudi Arabia Alia Trading Corporation P. O. [. . . ]