User manual ACER V273HL

[. . . ] (When the button is pressed to change the input mode, a message appears in the upper left of the screen displaying the current mode -analog or digital input signal. ) If you select the digital mode, you must connect your monitor to the graphic card's DVI IN(HDCP) port using the DVI cable. >> Click here to see an animation clip Use this button for auto adjustment. >> Click here to see an animation clip Use this button for turning the monitor on and off. This light glows blue during normal operation, and blinking blue once as the monitor saves your adjustments. AUTO button Power button [ ] Power indicator See PowerSaver described in the manual for further information regarding power saving functions. [. . . ] Connect the other end of the cable to the red terminal at the back of the speaker. Connect the light green cable of the cables provided when purchasing the speaker to the audio output terminal at the back of the computer. Connect the other end of the cable to the light green terminal at the back of the speaker. / Connect a headphone to the black terminal at the right of the speaker. Connect a microphone to the red terminal at the right of the speaker. By turning part ( + , - ) in the direction shown in the figure below, the speaker turns on and the volume increases. Connect the power line connected to the speaker to the black terminal of the monitor. It is connected to a monitor for the required power. Using the Stand Sliding stand Stand Stopper Swivel stand Using ( ), You can swivel the monitor left and right at an angle of 350° to set the monitor lengthwise. When you try to rotate the monitor in the state of the power cord or cable connecting to the monitor, the power cord of cable can be destroyed. Tilt angle Using ( ), You can adjust the tilt anlgle within a range of 3° forward to 25° backward for the most comfortable viewing angle. Attaching a Base This monitor accepts a 200 mm x 100 mm VESA-compliant Mounting interface pad. Monitor Mounting interface pad (Sold separately) 1. Lay the LCD monitor face-down on a flat surface with a cushion beneath it to protect the screen. Remove four screws and then remove the stand from the LCD monitor. 4. Align the mounting interface Pad with the holes in the rear cover mounting pad and secure it with four screws that came with the arm-type base, wall mount hanger or other base. Do not use screws longer than the standard dimension, as they may damage the inside of the Monitor. Is the screen displaying only one color as if looking at the screen through a cellophane paper?Have the screen colors become strange after running a program or due to a crash between applications?Has the video card been set properly? The screen shows strange colors or just black and white. Check the signal cable connection. Make sure the video card is fully inserted in its slot. Reboot the computer. Set the video card by referring to the video card manual. The screen suddenly has become unbalanced. Have you changed the video card or the driver?Have you adjusted the resolution or frequency to the monitor? Adjust screen image position and size using the OSD. Adjust the resolution and frequency at the video card. (Refer to the Preset Timing Modes). The screen can be unbalanced due to the cycle of the video card signals. Is the frequency properly adjusted when checking the Display Timing on the menu?(Refer to the Preset Timing Modes). Adjust the frequency properly by referring to the video card manual and the Preset Timing Modes. (The maximum frequency per resolution may differ from product to product. ) There are only 16 colors shown on the screen. The screen colors have changed after changing the video card. Windows XP : Set the resolution at the Control Panel Appearance and Themes Display Settings. Windows ME/2000 : Set the resolution at the Control Panel Display Settings. Has the video card been set properly? [. . . ] You need to reboot the computer for it to operate normally after installing or removing the program. Visit the MagicTuneTM website and download the installation software for MagicTuneTM MAC. Check if the power cord and the video cables are properly connected to the computer. Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor. If your monitor screen remains blank after using the previous procedure, check your video controller and computer system; your monitor is functioning properly. [. . . ]