User manual ACER TRAVELMATE P273-MG

[. . . ] Getting Started . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Function Keys. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 LCD Display. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Insert a Battery. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Press the Play/Pause Battery Status Empty Full button to check the capacity of the battery. 6. If you cannot read the Battery Status on the Display when the battery is inserted, please return to step 1 and once again make sure the battery is inserted into the correct alignment. 11 Battery Consuming Reference Category of Battery AAA Alkaline 1280mA/hr battery Note:1. Recording Max 12 hours for voice or FM radio recording playback Playing Max 12 hours for audio Alkaline battery is recommended when using this Drive. Make sure the battery is taken out if you are not going to use 12 Hold Switch This MP3/Storage Drive provides a Hold Switch, which is located on the side of the Drive for preventing any miss touching while the Drive is recording or playing. Once the hold switch is slide to the lock position, all function keys on the Drive will be disabled instantly. 13 Chapter 3. Plug one end of the supplied USB cable to your computer, and plug the other end to the MP3/Storage Drive. And the MP3/Storage Drive should be detected by the operation system automatically. Note: If the operation system of your computer is Windows 98SE, a hardware driver for the MP3/Storage Drive will be required. 14 Hardware Installation for Windows 98SE only For Windows 98SE operation system, it will automatically detect the new hardware when the MP3/Storage Drive is first connected to your computer. Please follow the following instructions to install the driver for this MP3/Storage Drive. Click Finish, and the driver is installed successful. 17 Power On and Off 1. To power off the USB Device, press and hold the Play/Pause the Play/Pause button until the power is switched off. While you are long pressing button to power off the MP3/Storage Drive, you will see a Power Off Status Bar appearing on the Display to show you the Power Off status, and note that it takes about three to five seconds to turn the power off. 18 Editing Sound Tracks (Files) 1. Now, press the Menu button again to save the selected frequency to the selected favorite station number. 5. Once the desired stored favorite station appears on the Display, release the button. Press and hold the REC button located next to the Fn button for 2 seconds, and then release the REC button. 3. Once the REC button is long pressed and then released, the selected station frequency will now start being recorded. On the Display, users should read that a recording FM file is generated and place under the folder of [ /VOICE/ ]. The recording file name sequence starts from [ F001. WAV ], and then [F002. WAV ], and so forth. 4. The maximum length of the recording depends on how much available memory space is left while recording. To play a recorded FM voice file, press down the Menu button once, and then push the Menu button to the right once, and now you should read the message of VOICE appearing on the Display. 30 2. Press down the Menu button again, and then use the Menu button to select a desired recorded FM voice file by pushing the Menu button to the right or to the left. 3. Once the desired voice file is selected, press the playing the file. button to start 4. Note that while you are searching for the desired recorded voice file, all the recorded FM voice files will be displayed by sequence. [. . . ] If select DISABLE, and the backlight of the LCD Display will always illuminate. 45 4. When a selection is decided, press down the Menu button once to confirm the selection. Contrast Under this Contrast setting, you are able to set the contrast of the LCD Display. Under this Backlight setting, you are able to set a time to turn off the backlight of the LCD Display automatically. Press down the Menu button once, and then push the Menu button to the right three times, and now you should read the message of SETTINGS appearing on the Display. 2. [. . . ]