User manual ACER S243HL

[. . . ] The contents of your box may differ. ACER Officejet 5600 All-in-One series Setup Guide 4 a Attach the control panel faceplate (if not attached) a Align the control panel faceplate with the device. b Moving from left to right, press down each of the areas shown in graphic b until you securely attach the faceplate. [. . . ] Make sure you hook the top edge of the tray into the light gray latches, and then lower. 2 · ACER All-in-One e Flip the paper tray extender. 6 Connect the power cord and adapter Important: Do NOT connect the USB cable until Step 16 or software may not install properly. 7 Connect the supplied phone cord Connect one end of the supplied phone cord to the phone port on the left (1-LINE) and the other to a wall jack. To connect an answering machine or use your own phone cord, see the User Guide. 8 On Press the On button and configure a After you press the On button, the green light flashes, and then becomes solid. Use the arrow keys to select your language, press OK, and then confirm. Use the arrow keys to select your country/region, press OK, and then confirm. 9 Open the access door Lower the access door. If you have a carriage jam, see Troubleshooting on the last page. ACER All-in-One · 3 10 Remove tape from both cartridges Pull the pink tab to remove the tape from both print cartridges. Do not touch the copper-colored contacts or retape the cartridges. 11 a Insert the tri-color print cartridge b The device must be On before you can insert the print cartridges. (This may take several minutes. ) Once the prompt appears, connect the USB cable to the port on the back of the ACER All-in-One, and then to any USB port on your computer. b Double-click the ACER All-in-One Installer icon. After you complete software installation, you are finished. If you do not see this screen, see Troubleshooting in the last section. After you complete software installation, you are finished. ACER All-in-One · 7 Troubleshooting *Q5610-90132* *Q5610-90132* Q5610-90132 Problem: The Carriage jam message appears on the display. Press the ON button after you have removed all packing materials. Problem: The Remove and check print cartridges message appears after you insert print cartridges. Re-insert the cartridges, and then close the access door. Problem: (Windows only) You did not see the screen telling you when to connect the USB cable. Refer to Step 15. Problem: (Windows only) The Microsoft Add Hardware screen appears. [. . . ] Refer to Steps 15 and 16. Problem: (Windows only) The Device Setup Has Failed To Complete screen appears. Refer to Steps 4 and 16. Problem: A copy of a photo does not look right. [. . . ]