User manual ACER PF-801

[. . . ] 6. Headphone jack is used for attaching headphones or self-amplified speakers. Insert a straightened paper clip to eject the tray manually. User's Guide 1 Rear View DIGITAL AUDIO DG AUDIO RGGL CABLE SELECT SLAVE MASTER CSM SLA 39 40 IDE INTERFACE 1 2 DC INPUT 5V G G 12V 6 5 4 3 2 1 1. [. . . ] Insert a straightened paper clip to eject the tray manually. User's Guide 1 Rear View DIGITAL AUDIO DG AUDIO RGGL CABLE SELECT SLAVE MASTER CSM SLA 39 40 IDE INTERFACE 1 2 DC INPUT 5V G G 12V 6 5 4 3 2 1 1. 3. Power supply connector connects the CDROM drive to the computer's power supply. Interface connector connects the PF-801 drive to the 40-pin IDE interface cable. Device configuration jumper is installed on "SL" for slave mode by default. The PF-801 drive can be configured as a master drive if the jumper is installed on "MA". For DOS and Windows 3. 1, the procedure for installation is as follows: User's Guide 3 1. Insert the PF-801 Device Driver disk into a 3. 5" floppy disk drive. At the command prompt, type the drive letter of the drive you're using, followed by a colon (:), and then press Enter. It is recommended that you use Express Setup; however, you can use Custom Setup if you are an experienced user. 6. 7. NOTE: Please read the README file in the device driver disk to learn more about using this drive. Emergency Eject If for any reason the tray does not eject automatically, insert and press an eject-bar inside the emergency eject hole to manually eject the tray. [. . . ] It is recommended that you use Express Setup; however, you can use Custom Setup if you are an experienced user. 6. 7. NOTE: Please read the README file in the device driver disk to learn more about using this drive. Emergency Eject If for any reason the tray does not eject automatically, insert and press an eject-bar inside the emergency eject hole to manually eject the tray. [. . . ]