User manual ACER AL1914

[. . . ] Do not allow sharp objects such as knives, pens, or pencils near the screen. If such objects touch the screen, the LCD panel will be permanently scratched. [. . . ] In this case, the screen is recovered slowly by changing the image or turning off the Power Switch for hours. 2 Package contents LCD Monitor Power Cord VGA Cable Audio Cable User Manual (CD) Quick Start Guide Installation instructions Assembling the Monitor acer acer 1. Connect the stand into the neck of the monitor along the track. 3 Detaching the Monitor If you need to repackage the monitor, please separate the monitor and base, and restore them to the carton. Separate the monitor and base and put them into carton. Important First, find a clean, flat surface to place the monitor after removing it from the stand. Pull the monitor slightly up and away from the stand. Adjusting the Viewing Angle The viewing angle of the monitor ranges from 0°~20°. 4 Connecting the Devices Caution: Make sure that the computer and the monitor are both disconnected from the power supply. AC IN AD IN UIO D-SUB IN 2 3 Audio VGA 1 AC 3 Audio 2 VGA 1 AC Power Code VGA Cable Attach the monitor to the power cord which should then be inserted into a properly grounded electric socket. Connect the signal cable to the VGA input socket of the monitor , and connect the signal cable to the VGA output socket of the graphics card on the computer. Connect the audio input socket of the LCD monitor and the computer by means of the audio cable. Audio cable WARNING: The D-Sub 15 pin plug of the VGA cable is trapezoid in shape. Make sure the shape of the plug matches the shape of the socket it is inserted into, and that none of the pins are bent or otherwise damaged. Switching the Power First, switch the power on to the monitor, then switch the power on to the computer. When you see the LED on the power button go green, this indicates the computer is ready for use. If you do not see the green light on the power button or a video signal, check the connections. 5 Adjusting display settings 1234 AUTO 5 < > MENU External Controls 1 AUTO If OSD is active, press to exit a selection in OSD. If OSD is inactive, press and the monitor will automatically optimize the position, focus and clock of your display. If OSD is inactive, press once, then press the buttons marked < or > to adjust the volume. If OSD is inactive, press once, then press the buttons marked < or > to adjust the volume. [. . . ] Inspect the monitor's video cable and ensure that none of the pins are bent. Press select/auto key and the monitor will automatically optimize the position of your display. [. . . ]