User manual ACER AL1714

[. . . ] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Quick Installation Complete the following steps for quick installation: (See the figure) Assemble the seat of the display Take the seat out of the box and place it on a flat table. Take your LCD display out of the carton and assemble the display and seat along the rail. You will hear a click sound when the display and seat are engaged correctly. Connection to PC Make sure that the power supply of your PC is turned off and the power plug is removed. Connect and fasten both ends of the signal cable to your PC host and LCD display respectively. If your LCD display has built-in speakers, connect the audio cable attached to the display from the sound card output of your PC to the audio input on the back of your LCD display. Signal Cable Audio Cable Transformer DC end 2 Adjustment of Display Key Definition Power Source 1 2. 3 4 5 Menu > < Auto OSD Menu Plus Minus Automatic Adjustment Power On/Off Green indication: Power is on and normal Orange indication: Sleep status in the energy-saving mode Colorless indication: Power off Press this button to enter OSD. Press this button and click < and > to adjust volume when OSD is not shown (for the model with speakers only) Press this button to exit the manual when OSD is shown. Press this button for the display to optimize the position, phase and clock pulse automatically when OSD is not shown. 6 Speaker (For the model with speakers) 3 Operation Your LCD display has been adjusted to its optimal status before shipment. Your can also adjust the image in accordance with the following illustrations and steps. 4. Click MENU to display the OSD window as shown in the following figure. Click < or > to select the function to be adjusted as shown in the following figure. To exit OSD, select " " to close the OSD window and save changes. [. . . ] Remove the electronic equipment in the vicinity that may cause EMI interference. Check the signal cable of the display and ensure that no pin is bent. Image Offset or wrong Size Press the auto adjustment button to optimize the screen automatically. Set up the reference position. 6 Technical Specifications Panel Dimension Max. [. . . ]