User manual ACER AL1517

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reposition or relocate the receiving antenna. · Increase the separation between the equipment and the receiver. [. . . ] Though the LCD Monitor uses very little power, some ventilation is needed to ensure that the Monitor does not become too hot. After you unpack the LCD Monitor, make sure that the following items were included in the box: * LCD Monitor * Base * User's Manual * Quick Setup Guide * 1. 8M Monitor-to-PC D-SUB Cable * 1. 8M S-tereo Jack Audio Cable * 1. 8M Power Cord If you find that any of these items is missing or appears damaged, contact your dealer immediately. Connecting the LCD Monitor and Base Take the base from the package, and place it on a stable surface (e. g. , desk or table). 1. Figure 1-1 Viewing Angle Adjustment The LCD Monitor is designed to allow users to have a comfortable viewing angle. 1-2) Figure 1-2 Warning Do not force the LCD Monitor over its maximum viewing angle settings as stated above. Attempting this will result in damaging the Monitor and Monitor stand. 5 Detaching LCD Monitor from Its Stand Unscrew screws the swivel base support column and pull down the hinge to release. Figure 1-3 Interface for Arm Applications Before installing to mounting device, please refer to Fig. 1-3. The rear of this LCD display has four integrated 4 mm, 0. 7 pitches threaded nuts, as well as four 5 mm access holes in the plastic covering as illustrated in Figure 1-4. These specifications meet the VESA Flat Panel Monitor Physical Mounting Interface Standard (paragraphs 2. 1 and 2. 1. 3, version 1, dated 13 November 1997). Figure 1-4 Connecting the Display 1. Connect one end of the signal cable to the LCD Monitor's D-SUB port. (See Fig 1-5) 3. Connect the other end of the signal cable to the D-SUB port on your PC. Make sure connections are secure. Figure 1-5 Connecting the AC Power 1. Connect the power cord to an AC power source. Figure 1-6 6 Connecting the Audio Cable (option) 1. Connect the audio cable to the " LINE OUT " jack on your PC's audio card or to the front panel's "AUDIO OUT" jack of your CD ROM drive. Connect the other end of the audio cable to the LCD Monitor's " AUDIO IN " jack. Figure 1-7 Power Management System This LCD Monitor complies with the VESA DPMS (version 1. 0) Power Management guidelines. The VESA DPMS provides four power saving modes through detecting a horizontal or vertical sync. When the LCD Monitor is in power saving mode, the monitor screen will be blank and the power LED indicator will light yellow. 7 Chapter 2 Display Controls General Instructions Press the power button to turn the monitor on or off. The other control buttons are located at front panel of the monitor (See Figure 2-1). By changing these settings, the picture can be adjusted to your personal preferences. The power indicator will light up. Figure 2-1 External Controls 1 2 3 Auto Adjust Key/Exit < > 4 5 6 Menu/Enter LED / Power Key 8 Front Panel Control /Power Button: Press this button to turn the monitor ON or OFF, And display the monitor's state. [. . . ] PROBLEM There is no picture on LCD Monitor If there's no picture on the LCD Monitor, please perform the following steps: 1. Make sure the power indicator on the LCD Monitor is ON, all connections are secured, and the system is running on the correct timing. If there is still no picture, press the Adjustment Control button several times. [. . . ]